Skip to main content

    AV Design for Charlotte Open-Plan Great Rooms: Hiding TVs, Speakers and Wiring

    By , Founder of Peters Audio Video ·

    How to plan audio and video for the open kitchen-and-great-room layouts common in Charlotte homes, without a black box on the wall or speakers on the floor.

    Short answer: in an open great room, decide the TV wall, the equipment location and the speaker zones before drywall. Put equipment in a ventilated closet instead of under the TV, use in-ceiling or invisible speakers split into kitchen and seating zones, and plan for daylight glare from the large windows typical of Charlotte new builds.

    Why open plans are harder than they look

    Many new homes in Ballantyne, Weddington and the Lake Norman area open the kitchen, breakfast area and family room into one space with tall ceilings and a wall of glass. Sound carries everywhere, the fireplace often claims the obvious TV wall, and afternoon sun hits the screen. Good Charlotte audio-visual design solves those three problems first.

    1. Choose the TV wall with the seating, not the fireplace

    A TV mounted high over a fireplace is uncomfortable to watch. Where the fireplace must be the focal point, consider a pull-down mount, a recessed niche at eye level beside it, or a display that doubles as artwork. Check the viewing angle from the actual sofa positions on the floor plan.

    2. Move the equipment out of sight

    Receivers, streamers and cable boxes do not need to live under the TV. A small ventilated closet or a central rack keeps the wall clean and makes service easier. Run conduit from the TV location to that closet so new connections can be added later. Our low-voltage wiring page covers the infrastructure.

    3. Split the sound into zones

    One set of speakers for the whole room rarely works. Treat the kitchen, the seating area and any breakfast nook as separate zones so music can play softly while cooking and louder during a game. In-ceiling speakers aimed at the seating, or plaster-in invisible speakers, keep the ceiling clean. More on this in our whole-home audio guide.

    4. Plan for glare

    Tall glass walls are why people buy these homes and why daytime TV can look washed out. Motorized shades on the worst windows, a display with good brightness, and a screen position perpendicular to the main glass usually fix it. See motorized shading in Charlotte.

    5. One simple control

    Everyone in the house should be able to turn on the TV and the music without a pile of remotes. A single remote or keypad and a phone app is the target; home automation ties lighting and shades into the same scenes.

    Pre-drywall checklist

    1. Mark the TV wall and mount height from the seating plan.
    2. Add backing for the mount and any pull-down hardware.
    3. Run conduit from the TV to the equipment closet.
    4. Pre-wire speaker locations for each zone.
    5. Run network cable to the TV and a ceiling access point.
    6. Pre-wire shade locations on west and south glass.
    7. Plan ventilation and power for the equipment closet.

    Questions and answers

    Can this be done in an existing home?

    Often, yes. Attic access above a great room makes ceiling speakers and wiring practical; walls may need small openings.

    What does it cost?

    It depends on the number of zones, displays and shades. Our smart home cost guide explains budgets by scope.

    When should I involve you in a new build?

    Before framing is finished, ideally when the floor plan is set. See new construction AV in Charlotte.

    Ready to plan your great room? Request System Design.

    Topics

    Related articles

    Request System Design · All journal articles

    Your Project

    Plan Your Whole-Home Audio System

    Your listening areas, preferred music services, ceiling details and whether speakers should be visible or concealed.

    Get in Touch

    Contact Us

    By Appointment Only